40-400 Mesh / Inch 0.200mm Shuttleless Weaving Machine

Main components and specification

In the direction of the technical flow for weaving, it mainly consists of: take-up unit, weft beating-up unit, opening unit, and warp feeding unit, etc.

Note-The light metal shuttle less wire mesh machine after setting up can produce Plain Dutch Wire Mesh, Reverse Plain Dutch Wire Mesh and Twill Dutch Wire Mesh. The Max. Mesh Size can up to 40 To 400 mesh

.

Operation

1. The weaving machine can be operated through press buttons and turn knobs, shown as Fig. 1.

1. The weaving machine can be started up and stopped at any running position.
2.  
3. It has the function of automatic stop and red/green light indication at weft or warp broken.
4.  
5. Turn the knob to the MANUAL stage to release the motor brake for manual trial running and adjusting.
6.  
7. Turn the knob to the AUTOMATIC stage and then press the FORWARD button to bring the weaving machine into normal operation.
8.  
9. At a fault of weft broken or warp broken, the weaving machine will be automatically stopped and the red/green light will give an indication. The weaving machine can be brought back into normal operation after the fault is removed, the STOP button is pressed down, and the indicator is turned off. If the indicator does not turn off when the STOP button is pressed down, and the weaving machine can not be brought back into normal operation even by pressing down the FORWARD button, it means the fault hasn't been removed yet.
10.  
11. When necessary, the weaving machine can be stopped at any running position by pressing down the STOP button.
12.  
13. The weaving machine will be brought into reverse running by pressing down the REVERSE button. Usually reverse running is required at any weft broken, but it is recommended not using this function frequently otherwise the rapier will break off the warp line or the motor will be damaged because of overheat.
14.  
15. The weaving machine will be inching by pressing down the INCH button, but it is recommended not using this function otherwise the motor will be damaged.
16.  
17. Installation and Tiral Operation